Printhead Assemblies Printhead assemblies in general consist of some or all of the following: a fluid reservoir; dispensing device; fluid interconnections between the reservoirs and dispensing devices; filter elements; connections to the pneumatic controller and inert gas source; connections to the electronics controller; heating elements and connections to temperature controllers; and mechanical mounting. All printhead assemblies listed below can be used on the jetlab® printing systems. Printhead subsystems can be integrated into custom printing or dispensing systems, as illustrated in the Hardware Selection Guide. Room & Low Temperature Printheads Low temperature printhead assemblies are designed for operation at room temperature or up to 50°C. PH-46 four fluid heated printhead assemby PH-47 single fluid printhead assembly, unheated PH-41 single fluid, cartridge style printhead assemby, heating optional PH-03 single fluid, small or no reservoir printhead assembly, unheated High Temperature Printheads High temperature printhead assemblies are designed for operation at temperatures up to 240°C. Input and heating for inert gas is provided in the PH-05a. PH-04a Polymer Jet™ printhead assembly PH-05a Solder Jet® printhead assembly with local inert environment [ home | about us | equipment | services | technology | news | contact us ]