The PH-03 Mounting Block holds one low-temperature MJ-AB barbed fitting dispensing device and provides a Luer fitting fluid connection and a Molex 70107 electrical connector. Mounting can be made to either a horizontal or vertical surface.
Mounting Block for low-temperature dispensing devices.
Low-temperature device with barb fluid fitting, xxx denotes orifice diameter in microns.
The PH-03 may be combined with a fluid reservoir and the following components and subsystems to create a functional subsystem.
JetDrive™ III controller, including command set and Windows based stand-alone control program, JetServer™. Includes built in strobe delay & level 02 firmware (complex waveforms).
Pressure / Thermal Controller with one manual pneumatic channel.
Electronic Pressure Controller and Pressure Mode Selector, single channel.
Basic Optics System: CCD camera, power supply, lens, fine focus, mounting block.
Drawings with dimensions
Equipment Selection Guide