:
PH-03 PDF Print E-mail
alt

Product Description

The PH-03 Mounting Block holds one low-temperature MJ-AB barbed fitting dispensing device and provides a Luer fitting fluid connection and a Molex 70107 electrical connector. Mounting can be made to either a horizontal or vertical surface.

Ordering Information

PH-03
Mounting Block for low-temperature dispensing devices.

MJ-AB-01-xxx
Low-temperature device with barb fluid fitting, xxx denotes orifice diameter in microns.

Support Equipment

The PH-03 may be combined with a fluid reservoir and the following components and subsystems to create a functional subsystem.

CT-M3-02
JetDrive™ III controller, including command set and Windows based stand-alone control program, JetServer™. Includes built in strobe delay & level 02 firmware (complex waveforms).

CT-PT-21
Pressure / Thermal Controller with one manual pneumatic channel.

CT-PT-A1
Electronic Pressure Controller and Pressure Mode Selector, single channel.

CM-VS-03
Basic Optics System: CCD camera, power supply, lens, fine focus, mounting block.

Additional Information

Brochure (PDF)
Drawings with dimensions
Equipment Selection Guide
Integration Guide
Cleaning Guide