:

PH-05a

PH-05a

Product Description

alt The PH-05a drop-on-demand printhead is designed for dispensing oxygen and/or water sensitive materials at temperatures up to 240°C. Integrated heated inert gas injection is used to creating a local inert environment at the orifice of the dispensing device and around the drop in flight.

The PH-05a uses the same interchangeable high temperature dispensing device, the MJ-SF, as does the PH-04a Polymer Jet™ printhead. Drop volumes ranging from 5 pL to as high as 0.5 nL have been dispensed. Using MicroFab’s patented drive waveforms, the range of the drop volume obtainable without changing the dispensing device can be a factor 3 or better.

Standard Features

Operation to 240°C; 30 mL capacity stainless steel reservoir; separate heaters for reservoir and dispensing device, allowing different operating temperatures; compatible with Jetlab® 4xl, Jetlab® 4xl-A, and Jetlab® II.

Available Options

MJ-SF devices available in orifice diameters 10-80µm.

Ordering Information

alt PH-05a
High Temperature Printhead with Integrated Inert Gas Injection.

MJ-SF-04-xxx
High-temperature device with VCO fluid fitting, xxx denotes orifice diameter in microns.

Support Equipment

The PH-05a may be combined with a fluid reservoir and the following components and subsystems to create a functional subsystem.

CT-M3-02
JetDrive™ III controller, including command set and Windows based stand-alone control program, JetServer™. Includes built in strobe delay & level 02 firmware (complex waveforms).

CT-PT-21
Pressure / Thermal Controller with one manual pneumatic channel and with two T-01 temperature controllers.

CT-PT-A1
Electronic Pressure Controller and Pressure Mode Selector, single channel.

CM-VS-03
Basic Optics System: CCD camera, power supply, lens, fine focus, mounting block.

Additional Information

Brochure (PDF)
Drawings with dimensions
Equipment Selection Guide
A Basic Ink-Jet Setup
Cleaning Guide